FrameMaker Crashing on Print to PS: a Clue or Two Would Be Nice

["Hedley Finger (EPA)" <Hedley.Finger@xxxxxxxxxxxxxxx>]

All:

A PS file was successfully created by printing to the AdobePS 4.3 driver
which was set to create a file.  An incomprehensible font warning appeared.
This file then 'successfully' distilled but all characters were turned into
little rectangles EXCEPT for anything in Courier.

But, when using FrameMaker's inbuilt 'print to file', it 
crashes while printing to PS or saving to PDF.  This occurs whether I use
AdobePS 4.3 with the HP LaserJet 4si or Distiller 3.02 PPD.  There are no
PostScript fonts on the system, only TrueType.  A FrameLog file full of hex
garbage is produced.

[FrameMaker 5.5.6, FrameScript evaluation installed, Acrobat Distiller 3.02,
Acrobat Reader 3.02 and 4.0, AdobePS 4.3 with Distiller 3.02 PPD printing to
file or HP LaserJet 4si PPD printing to file or paper, all TrueType fonts,
Windows 98, HP OmniBook 2100]

Regards,
Hedley Finger
Technical Writer

Ericsson Australia Pty Ltd
StarHUB NMOSS Project
Level 34.66, Melbourne Central Tower
Elizabeth Street
Melbourne VIC 3000
Tel. +61 3 9301 6214
Cell. +61 412 461 558
Fax. +61 3 9301 6199
Email. hedley.finger@ericsson.com.au

Hand Holding Projects Pty Ltd
Tel. +61 3 9809 1229
Cell. +61 412 461 558
Fax. +61 3 9809 1326
Email. hfinger@handholding.com.au



** To unsubscribe, send a message to majordomo@omsys.com **
** with "unsubscribe framers" (no quotes) in the body.   **