Postscript/Docutech Printing Problems

[smurphy@xxxxxxxxxxxxxxx]

I just printed a software manual to a Docutech (delivered the PS files to   
a printer who ran the job). In the past this has worked well for me, but   
this time I ran into a couple of problems:

1) I have a diagram that I created in Visio and saved as a .WMF; it looks   
okay except for text with bullets (text created in Visio, not FM). The   
bullets show up as a lower case "y". The font is TrueType Arial.

2. There is an appendix for which I created a set of rotated master pages   
(one for left, one for right). The pages contain tables. The right-hand   
page printed fine but the left-hand page printed too high on the page,   
cutting off the header and part of the table. This was the only page in   
the entire manual that did this (am wondering if the Docutech itself   
could have printed this improperly).

The document was printed to a size of 7 x 8.5 inches using FrameMaker   
5.5.6 on a Windows 95 platform.

TIA for any solutions...!

Steve Murphy
Senior Documentation Specialist
Adobe Certified Expert/FrameMaker, Acrobat
SOFTWORKS, Inc.
5845 Richmond Highway
Alexandria, VA  22303 USA
(703) 317-8879
smurphy@softworkscc.com  

** To unsubscribe, send a message to majordomo@omsys.com **
** with "unsubscribe framers" (no quotes) in the body.   **